cell mill for Metformin hydrochloride

Cell Mill for metformin hydrochloride is one of the important basic technologies in the modern industry. In modern industries, the raw materials that require powder state have a small and uniform particle size and higher purity, and ultrafine raw materials. Its nature changes, which makes ordinary materials have a broader application range,

Cell Mill for metformin hydrochloride is mainly used for more refined materials. The pulverized particle diameter is 1.5 to 0.005 mm, and the crude material is sieved.
The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settled in the air than in the water. Moreover, the density and viscosity of the air vary with temperature and pressure.

In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine product is usually taken away by the airflow. In some cases, the raw material is sent to a pulverized device from the airflow.

As is well known, the load of solid particles in the air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical direction is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverized coal and Western / cubic centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the suspension has a certain density and particle size.The gas flow rate required for the particles is greater than the calculated value of free settling, which is due to the unevenness of the velocity distribution of the gas flow along the pulverizing chamber portion.

This Cell Mill for metformin hydrochloride has the characteristics of high pulverization, high pulverization efficiency, high pulverization accuracy, accurate cut particle size, and good stability.
ALPA White Carbon Cell Mill for Metformin Hydrochloride Case Sharing: The company is a company engaged in white carbon black production. A ultrafine pulverized apparatus for producing two granular white carbon products can be produced in the production process. After investigation, we finally purchased our AlPa's Cell Mill for Metformin Hydrochloride.

Finished granularity: D50: 6.78 D90: 12.8μm
Production capacity: 30kg


AlPa Technology recommends that you are using ultrafine air grade machine, jet classifier When the equipment such as a powder classifier must pay attention to the performance of the equipment periodically to prevent malfunctions during use.