Turbo Mill of Kettle residue polymer

In the classification operation of industrial production at this stage, the use of Turbo Mill of Kettle Residue Polymer is mainly targeted by the effective pulverization of solid particles, and is the case where we are more commonly used in the product ultrafine pulverization process. .

The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settled in the air than in the water. Moreover, the density and viscosity of the air vary with temperature and pressure.

In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine product is usually taken away by the airflow. In some cases, the raw material is sent to a pulverized device from the airflow.

As is well known, the load of solid particles in the air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical direction is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverized coal and Western / cubic centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to airflowThe velocity distribution along the pulverized chamber is uneven.

The Turbo Mill of Kettle Residue Polymer has a wide range of crushing, high pulverization efficiency, high pulverization precision, accurate cutting particle size, and good stability.

ALPA baked wheat Turbo Mill of Kettle Residue Polymer case sharing: This customer is a seasoning company, in the production process, it is necessary to use a device that can make ultrafine pulverized wheat after baked wheat. . Investigate a number of domestic companies, and finally chose our AlPA as a partner, purchased Turbo Mill of Kettle Residue Polymer from us.

finished particle size: D99.9: 180 mesh
Production capacity: 400kg

Shandong Alpa Powder Technology Co., Ltd. mainly engaged in the production of Turbo Mill of Kettle Residue Polymer product technology Welcome to consult with development and service. With good quality and service, affordable prices, customers provide airflow crushing products and services for customers.