Hammer Mill of silicon carbide

Hammer Mill of Silicon Carbide can be used in the current stage of industrial production process, and AlPA has been committed to the development and application of equipment such as grades for many years, and we produced during the development process of many years. The classification machine has gradually begun to develop in the direction of modernization, and we believe that we can provide a complete set of production planning programs for our customers.

Hammer Mill of Silicon Carbide's temperature increases, and when the temperature of the working fluid is too high, the flow rate of the gas will increase. Taking air as an example, the critical speed at room temperature is 320 m / sec, and when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.

Technical parameters:
finished particle size: 200 mesh 90% passed
production capacity: 4-5T