Rod Pin Grinder for Yttrium Oxide

In this economically flourished area, many people know that Rod Pin Grinder for Yttrium Oxide, crusher technology is in a leading position in the same industry.

The following is a detailed description:

1. Feed granular control

Most ROD PIN Grinder for Yttrium Oxide has a certain upper limit requirement for the feed particle size. After entering the pulverization cavity, it can be sufficiently accelerated before collision and crushing with other particles. It is difficult to completely accelerate after large particles enter the pulverized cavity, which will allow them to stay in the machine too long, resulting in too high energy consumption. Therefore, in large-scale production of ultrafine powder, it is an effective way to pre-ground the raw material of the particle size is an effective pathway for energy saving.
2. Working medium

Currently, the working medium of ROD PIN Grinder for Yttrium Oxide is mainly compressed, superheated steam, inert gas, and the like. The choice of working fluid has a certain impact on crushing effects and economics. Superheated steam is superior to air in fluidity and critical flow rates to achieve higher flow rates and uniform flow fields. However, using superheated steam as a working fluid, it must be ensured that it is still in an overheating state before entering the product capture device, otherwise the material is condensed.
3. Feeding speed

Feeding speed is an important parameter reflecting gas flow grinding production capacity. During the pulverization process, the optimum ratio of the intake flow rate and the feed speed is the key to improving the crushing efficiency. In general, under certain intake flow conditions, the feed speed is proportional to the particle size of the product. However, the feeding speed is too fast, which will increase the particle density, mutual interference, disadvantage of the particles, and difficult to achieve the sufficient and effective collision between particles, affect the crushing effect; although the feed speed is too slow, the particles stay in the crush area The time can be extended, which will reduce the particle density, reduce the collision rate, resulting in a decrease in production capacity and an increase in unit production energy consumption.
4. Granular limit

Rod Pin Grinder for Yttrium Oxide In the pulverization process, as the particle size of the material is reduced, the crystallization and intensity of the material increases. After reaching a certain degree, the particle size of the material is no longer reduced or reduced, that is, the crushing limit of the material is reached. At this time, the material specific surface area increases, the surface activity of the particles, the particle agglomeration and grinding are in a dynamic equilibrium state, even if the grinding time is prolonged, it is difficult to further reduce the particle size of the material.


AlPa Baby Rod Pin Grinder for Yttrium Oxide case sharing: The company is a chemical enterprise, you need to make super-smashing of small soda, investigate a number of powder equipment companies, and finally chose our Alpa's Rod Pin Grinder for Yttrium Oxide .
Technical parameters:
Finished granularity: D97: 20μm
Production capacity: 10-220kg

Rod Pin Grinder for Yttrium Oxide's daily maintenance is a very important part, below Introduce the maintenance method of Rod Pin Grinder for Yttrium Oxide.
1. When the machine starts or starts, the appropriate amount of grease should be applied to ensure its life.
2. Check if the screws and nuts of each component are tightened. Check if the belt is smashed, whether it is tight.
3, regularly check the reliability of the equipment, prevent accidents or accidents.
4, the direction of operation of the spindle should be correct. If it is incorrect, it should be handled in time to avoid damage to the machine.

6, electrical components and lines should be checked regularly, whether it is intact, and the ground is reliable.
7. The equipment should be cleaned in time to prevent the next use to avoid contaminating materials.

ALPA produced Rod Pin Grinder for Yttrium Oxide is a high quality device, supports according to demand, the equipment model is complete, the efficiency is high, low energy consumption, easy operation, 24 hours can consult!