FL/ITC Multiple Classify Wheel Classifier of Polyethylene terephthalate

In the conventional dispersion pulverization process, it is difficult to overcome the material heating, viscosity, and the like. The machine uses a swirling high-speed rotational movement to produce a strong gas stream within the mill. The material enters the crushing room under the negative pressure of the feed port. The vortex vibration generated by the strong gas flow between the blade and the module is generated by impact, shearing and grinding. The heat of the pulverizer is taken away by the airflow, and the heat generated during the crushing process will not accumulate. The finished powder from the screen stream, improves the milling fineness, can be adjusted by the screen production efficiency, uniform fineness.

Today, let's take a look at the usual FL / ITC Multiple Classify Wheel Classifier of Polyethylene Terephthalate is maintained. First, the wind turbine 1, because the blades in the fan are particularly easy to accumulate, so it is necessary to clean the dust in the fan every week. 2, put the bearing chamber once a month. 3. If there is an abnormality in the fan, it is necessary to stop the ultrafine airflow classifier for inspection. Second, the host 1, you should check the graded impeller, spiral feeder, smash nozzle each year, see if there is wear, whether there is a place to replace. 2, run to a certain amount of time, in order not to affect the use of the ultrafine gas flow classifier, some parts must be cleaned. 3, the bearing should make the right amount of lubrication, too much will abnormally. Third, the planet waste valve 1, if the ultrafine airflow classifier has an abnormality, it must be downtown immediately. 2, the impeller and the body's inner warehouse should be cleaned every three months. 3, plus lubricants must have once every three.