FL/ITC Multiple Classify Wheel Classifier with kaolin

FL / ITC Multiple Classify Wheel Classifier With Kaolin The working principle is composed of a classifier, a cyclone separator, a dust collector, and a guide. Under the pulverizer pulling force, the lower end of the gas pulverizer is moved upward to the grading area, and the coarse, and the fine product is separated from the high-speed rotation grading turbine. The cyclonic separator or dust collector is collected by the grading wheel, and the fine particles required to meet the particle size are collected, and the coarse particles are collected. The speed of the ellable fine particles disappears and falls along the two air ports of the cylinder wall. The crude particles and fine particles separated by strong purification of the two winds, and the fine particles rose to twice the grade region, and the crude particles drops to the discharge port.

For FL / ITC Multiple Classify Wheel Classifier With Kaolin, the fault solution is blocked, and the small class is said to talk about your opinion, I hope to have some reference roles. Crushes blockage is the most common fault of machinery. It may be one of the most common failures in mechanical design, but because improper operation can cause many faults. (1) The feeding speed is too fast, the load is increased, causing clogging. In the aquaculture process, pay attention to the deflection angle of the current table pointer at any time. If the rated current is exceeded, the motor overload and long-term overload will burn the motor. This situation should be reduced or closed immediately, but it can also be changed by increasing the feed speed to control the feed speed. Because the energy rolling mill is fast, the load is large, and the load fluctuates. Therefore, the current of the rolling mill is generally controlled around 85% of the rated current. (2) The incisor of the discharge tube is different or the interference is too fast, and the universal crusher is blocked, and the conveying equipment does not match, resulting in weakening or calm of the drainage pipe. In order to find outThe barrier is first necessary to clarify the export transportation equipment, do not change, adjust the amount of feed, and the normal operation of the equipment. (3) The water content, aging, screening, crushing and sealing material of the hammer hammer are too high, and the general grinding will be blocked. There is a need to regularly update the working state of the hammer aging and the serious aging, and check the screen regularly. Improve the production efficiency of universal grinding machines, improve the reliability of non-clogging and grinding.