FL/ITC Single Classify Wheel Classifier of Polyethylene terephthalate

Most of the product production and processing in the current stage use FL / ITC Single Classify Wheel Classifier of Polyethylene Terephthalate to make products for products, is one of the most common ways of processing, with the continuous improvement of scientific productivity The technique of grading equipment is also imminent. The performance and internal configuration of the grading equipment of the airflow must also keep the trend of the era to continue the upgrade of the product.

During the production process, the temperature rise of the bearing must be reconue, and when the temperature rise exceeds 50 ° C, it should be stopped, and the reason is to rule out the failure. . When the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the lining should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is replaced after the particle size is replaced. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-z7-degree anti-motor oil pressure oil, and the deceleration machine is used 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.