FW/HTS Multiple Classifying Wheel Classifier for Granulated sugar

FW / HTS Multiple Classifying Wheel Classifier for granulated sugar Transformation into a high-pressure airflow for pulverizing kinetic energy into a crushing cavity peripheral gas storage package is also a gas flow distribution station, and the airflow passes through the Ravar nozzle acceleration. After the acceleration gas flow is pulverized, the material and the venturi nozzle enters the crushing chamber synchronous accelerated grind. The acute angle of the Raval nozzle mounts the crushing chamber, so the flow cycle of the jet of the broken chamber and the animal feed, the particles are hit, collide, friction, and grind. The fine particles were opened into the center of the pulverizer, and the cyclone separator was entered into the drive of the heart gas, and the coarse powder was thrown to the periphery of the pulverizer, and cycled under the action of centrifugation and continued to be pulverized.

FW / HTS Multiple Classifying Wheel Classifier for Granulate Sugar features: high yield, low energy consumption, high grading efficiency. 2. Particle size: This unit is graded by an impeller. The stable grading process and special sealing measures effectively prevent the leakage of crude particles, so that the product has no large particles, the particle size is concentrated, and the grading accuracy is high. 3. The structure is reasonable, and 1-6 products can be produced at the same time according to user requirements. 4. Strong applicability: A closed or open joint operation can be combined with a variety of mill (air mill, mechanical mill, ball mill, Raymond mill, vibrating mill, etc.). 5. High degree of automation.

Let's talk about how to correctly use the FW / HTS Multiple Classified Sugar method 1. Prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works fine. Second, open 1. On the compressor power supply, the pressure valve and the main air valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power. 2. The zero start classification wheel is gradually adjusted to the specified speed. 3. Turn on the fan, the cyclone separator discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break. 4. The granularity of the finished wheel can be adjusted by grading wheel frequencies and charging.Third, the sequence of shutdown is: inverter - feeder - Main valve - Compressor - Steady wheel motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor. Fourth, repair 1. The motor should be lubricated regularly, but the grease should not be too large, the bearing temperature is too high. 2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable. 3. After a crushing material, after a certain period of time, it is necessary to remove the inner sticky of the chalk, so as to avoid blocking, thereby affecting the crushing effect. 4. After the filter bag is a period of time, it should be cleaned or replaced. 5. Precautions 1. When the discharge device is running, the unloading port cannot be extended to avoid accidents. 2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller and electricity will be damaged. 3. Regularly check the safety valve to ensure safety.

ALPA also believes that future airflow crushing technologies will become better and better, users who need to purchase such products can contact us.