Horizontal Single Classifying Wheel Air Classifiertalc

Horizontal Single Classifying Wheel Air Classifiertalc The use of industrial production in this stage can be said to be of great significance, and AlPA has been committed to the development and application of equipment such as classifiers for many years, and we produced in the development process of years. The classification machine has gradually begun to develop in the direction of modernization, and we believe that we can provide a complete set of production planning programs in a large range.

Horizontal Single Classifying Wheel Air Classifiertalc temperature increases, when the temperature of the working fluid is too high, the flow rate of the gas will increase. Taking air as an example, the critical speed at room temperature is 320 m / sec, and when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by overheating steam, the vapor pressure is typically from 0.8 to 1.7 MPa, and generally the pulverized calcined material is high, and the material after the pulverized surface is low.

In the production process, it should be paid to the maintenance and maintenance of Horizontal Single Classify Wheel Air Classifiertalc. 1. In the production process, the bearing temperature should be checked regularly. When the temperature rises above 50 degrees Celsius, the machine should be stopped to find out the cause and troubleshoot. 2, when the new machine is running, the transmission belt is easily elongated. Pay attention to adjust the appropriate tightness of the belt to ensure the life of the belt. 3, should be checked regularly, replace it in time, and ensure quality and production. 4, should check the wear of the blade and lining periodically. If the productivity is lowered after the wear, the grain size is thicker and the wear is immediately replaced. 5, the host and the hierarchical flow bearing use grease lubrication. 6, the replacement period of the bearing is 2000 hours, the amount of grease is 1/2 or 3/4 (lower test) of the bearing cavity space cannot be filled with too much fat. Otherwise, the axisThe temperature will be too high. 7, the spiral feeder changes the fat period of 4,000 hours, plus ordinary calcium based grease. 8, in the output shaft E, i.e., pulley E, avoid heavy hush, damage to the part. 9. It is strictly forbidden to turn the handle of the handwheel in the stop. 10. The lubricating oil used by the governor adopts N32 alkaline high-zinc high anti-milling oil, and the reducer uses 401 universal lubricants and cannot be replaced by other machines. 11. After 3000 hours, the new oil should be replaced, and then used after 500 hours of the second oil, then use it after 1000 hours.

To learn more about Horizontal Single Classifying Wheel Air Classifiertalc, you will go to Shandong ALPA Powder Technology Co., Ltd., the company has multiplied quality in research and development and production of crusher and crusher related products. Welcome, trustworthy.