Horizontal Single Classifying Wheel Air Classifier with Fishbone

Horizontal Single Classifying Wheel Air Classifier with FishBone is mainly used for more refined materials. The fractional particle size is 1.5 to 0.005 mm, and the crude material is sieved. The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settled in the air than in the water. Moreover, the density and viscosity of the air vary with temperature and pressure. In order to cause air flow, wind grading equipment typically requires an appropriate fan (exhaust or blast). When the airflow is classified, the fine particles are usually taken away by the airflow. In some cases, the feedstock is sent to the grading device with the airflow. It is well known that the load of solid particles in the air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement. The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for puls with a density of 1.5. Gram / cubic centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments. In the rising airflow, the water flow rate required to suspend a certain density and particle size is greater than the calculated value of the free settling, which is due to the uneven distribution of the airflow along the graded chamber portion. The Horizontal Single Classifying Wheel Air Classifier With FishBone has the characteristics of high grading range, high grading efficiency, high grading accuracy, accurate cut particle size, and good stability.

HorizoNTAL Single Classify Wheel Air Classifier With Fishbone Main Performance Features: 1, vertical hierarchical device, product particle size is adjustable between D97: 8-150 microns, good particle shape, narrow particle size It can be used in series with multi-stage classifiers and produces a product having multiple particle sizes. 2, the equipment is easy to disassemble, the inner wall is smooth, no dead angle. The entire system is closed, the dust is less, low noise, and the production process is clean and environmentally friendly. 3. The control system uses program control and easy to operate.

In the production of Horizontal Single Classifying Wheel Air Classifier With Fishbone, there will be a large amount of dust, if a large amount of dust will have a certain impact on the environment, how should we deal with it? How many methods are introduced below: 1. Install the dust collector: Generally, this dust collector can be used with powder classifier. It puts dust income trapping bag, dust is filtered by the dust box; 2, cloth bag Dust: the bag is tightly pulled with the machine, preventing leakage powder. Attention should be paid attention to parking, and it should be cleaned with dust during parking. 3, woodllar or pool dust removal: mainly using the ventilator to vacuum to the crushing, then vacuum, or vacuum through the pool.