cell mill of Paint residue

Publish: 2021-08-30 08:12:11

Views:

Most of the product production and processing of products in the current stage, using Cell Mill of Paint Residue, the use of Cell Mill of Paint Residue is a very common way of processing, accompanied by the continuous improvement of scientific productivity, and the technology of grading equipment It is also imminent to replace it. The performance and internal configuration of the grading equipment of the airflow must also keep the trend of the era to continue the upgrade of the product.

When the Cell Mill of Paint Residue screen material, the screen has good common performance under the air pressure of the rotating duct. At the same time, under the gravity of the air blower, the screen collects the qualified material, automatically discharges the material in the front cavity of the valve body by the unloading valve. The raw material powder driven by the compressed air is continuously supplied to the pulverizer without the need for rotating components. Through the precise control of the airflow into three products: F fine powder, m powder and G coarse powder, and collected in subsequent cyclone dust collectors and dust collectors.

The material is driven by the blower of the airflow pulverizer. The lower end of the pulverizer is moved upward to the pulverization zone, the strongest, and the strongest is separated under a high-speed rotary pulverized turbine. The fine particles that satisfy the particle size require the gap of the pulverizing wheel into the cyclone separator or dust collector. After collecting, some fine particles of the crude particles disappear and drops along the cylinder wall to two air ports. The crude particles and fine particles are separated by strong purification of the two winds, and the fine particles rises twice as the grade region, and the crude particles fall to the discharge exit.

ALPA seaweed feed Cell Mill of Paint Residue Case Sharing: The company is a seafood enterprise in Yantai. It is found that it can be smashed with seaweed during breeding. It can be used as sea cucumber feed to save feed purchase. cost. By comparing a long-term use of a Cell Mill of Paint Residue, you may save the cost of this production line for several years. The company purchased our AlPa Cell Mill of Paint Residue.

Technical parameters:

finished particle size: D90: 400 mesh
Production capacity: 400kg / h

MountainEast ALPA Powder Technology Co., Ltd. is a scientific and technological private enterprise producing various airflow pulverities, integrating development, manufacturing and application. The main product model has airflow pulverizer, air flow mill, medical gas flow pulverizer, disc air current pulverizer, eddy current pulverizer.

Previous: Hammer Mill for chemical fertilizer

Next: pin mill of Water atomization feni50